If the indicator light keeps flashing red, it means the battery is about to run out. Please replace it with a new one. If you do not use it for a long time, please take out the battery, which will help to save power and protect the lighting. Timer option prompt 1.2H: Press this button, the white light flashes twice, which means 2 hours on and 22 hours off for 24 hours, until the indicator battery turns off. 2.4 hours/6 hours 4H: Turn on for 4 hours, turn off for 20 hours (the white light will flash 4 times) 6H: turn on for 6 hours, turn off for 18 hours (the white light will flash 6 times) 4.TIME OFF: Turn off the timer, the indicator light will stay on until the battery power is off Waterproof skills 1. Make sure that the sealing ring is in the groove. Please tighten the cover as much as possible until it cannot be tightened to make it completely waterproof, and then put it in the water.
It is best not to use it in hot water, because the steam may enter the light, which will damage the components and cause the work to stop. When replacing the battery, please wipe off the water under the light to keep the battery box dry. Before use, please remove the plastic insulation film on the bottom of the remote control.
Please keep the remote control away from water, because it is not waterproof, and water will stop it from working. Before setting, please press and hold the button "on" for 3 seconds to activate the lights so that all lights are on at the same time. If some indicators do not respond in time, please press for a longer time. Since water absorbs a lot of signals, our lights support a remote control of up to 10ft / 3m underwater, please use it in 164ft / 50m in the air. Magnets are very suitable for any iron place that is easily attracted by magnets, especially rough vertical surfaces, but not suitable for smooth vertical surfaces.Please use suction cups instead. Magnet is a strong magnet, but it is best to use it on the surface of pure iron, the alloy will increase the absorption effect. The suction cup can be used on flat and smooth surfaces in air and underwater. But don't work on rough surfaces. Please clean the surface before installation to ensure that there is no debris between the surface and the suction cup. In particular, clean all lubricants that may come from shower cream, moss in the swimming pool, etc. Any lubricant will destroy it, so it is very important to clean the surface before installing the suction cup. If you want to remove the suction cup, please pull the suction cup vertically, do not pull the suction cup horizontally, otherwise it may be pulled out of the hole. This is a feature of the design. Please pay attention and use it in the correct way. Pls leave a note or send a message if any question. Return We offer 30 days return.
We'll do best to solve any problem. This item is in the category "Home, Furniture & DIY\Lighting\Fairy Lights".The seller is "securitydirect007" and is located in this country: CN. This item can be shipped worldwide.